DESCRIPTION OF AREA SERVICED
|
| 1 |
Load chain rotation: |
Check for looseness, aka “stretch” |
| 2 |
Load chain pan rotation: |
Inspect clearance to floor. |
| 3 |
Load chain rollers: |
Check for looseness, wear, or missing |
| 4 |
Scissor Arms: |
Check for wear at point of overlap on chain pin |
| 5 |
Chain Track: |
Inspect entrance and exit points for distortion |
| 6 |
Chain Track: |
Inspect for damage due to stretched load chain |
| 7 |
Curved stabilizing tracks: |
Inspect for wear/damage |
| 8 |
Cam Arm Rollers: |
Inspect for wear, or missing |
| 9 |
Lower Sprockets/Drive Sprockets: |
Check L/R alignment and set screws |
| 10 |
Upper Sprockets: |
Inspect for wear |
| 11 |
Motor Drive Chain: |
Check tension |
| 12 |
Torque Shaft Bolts: |
Tighten bolts if loose |
| 13 |
Wire Harnesses: |
Inspect integrity |
| 14 |
Safeties: |
Test for functionality (PE's, Touch Bar, Lwr Access, Lt Pnl) |
| 15 |
Run Modes: |
Test automatic mode for positioning accuracy |
| 16 |
Speeds: |
Observe pan rotation speeds, stopping accuracy |
| 17 |
Key Pad:
LED's |
Check all pan locations in: Auto, test reset pb & LED's, Pan LED's |
| 18 |
Voltage Check: |
Check incoming, outgoing, 5 & 12 volt circuits, etc. |
| |
LUBRICATION POINTS |
| 19 |
Load/Conveyor chain |
| 20 |
Scissor Arms at overlap where the chain roller attaches |
| 21 |
Chain Rollers |
| 22 |
Attachment points of the Cam Arm/Trunion plate assembly |
| 23 |
Top Sprockets |
| 24 |
Motor Chain |
| 25 |
Curved Stabilizing Tracks |
| 26 |
Vertical Chain Track |
